Wear Plate | Free Reports | Wisconsin

Case Studies

Thank you for requesting your free case study.

I've tracked the most common wear problems where I see industries struggle. By helping you identify your challenges, you can get them under control.

To give you the maximum useable information, the reports are focused by industry with their unique challenges :

Click on your industry below, and download your free Case Study report immediately.

1. How to Avoid the 6 Common Foundry Wear Plate Mistakes

Foundary version
Recycling version
Aggregate / Mining / Sand & Gravel version

2. Recycling Today Magazine - August 2009

How to select alloy steels vs. manganese replacement parts for automobile shredders.
This is the copy from an article I authored for Recycling Today Magazine, in their August 2009 issue. If you use manganese in any application, this article will give you the background to determine if manganese or an alloy steel component might give you longer life.

Wear Answers

"Simpson mixer blades made of AR plate with carbide inserts were only lasting 4 weeks. We replaced them with TriBraze and they now last 5 months."

"The AR400 wear bars on the back of our 400 Kobelco excavator bucket would need repairs after 600-800 hours. We replaced them with TriBraze wear strips which have passed 1500 hours, with some life left".

"We started using your products in a high wear cove area. We were getting approximately 4 weeks out of our existing AR-400 wear plate. We installed a piece of TriBraze and are now running 24 weeks before replacement with the same production levels."

"The sand chutes lined with AR400 on our wash plant would last one season. I replaced it with Super-C clad plate and it finished the 3rd season with a few more remaining."

The cast liner section in our rotary drum would last 12 - 18 months. We replaced them with formed TriBraze liners, and they show little wear after two years."

Customer Results

Industries